• Cerma STM-3
    Technology and
    Information

    Learn More
  • Cerma Motor Oil
    Technology and
    Information

    Learn More
  • Cerma Blue Ice
    Technology and
    Information

    Learn More
Honda 1300 Shadow

I am the guy who spoke with you at length and purchased some fuel treatment, oil additive and gun lube. I put the fuel and oil additives in immediately. I have also run 2 more tanks of fuel with treatment, reducing additive each time and the last tank had none applied. The bike is ...

Kurt P. Honda 1300 Shadow Friday, June 24, 2016
2008 Cadillac Escalade

Dear Cerma, I have attached a photo of the average MPG on the 2008 Cadillac Escalade which was treated at 183,743 Miles. At 183,901 miles, MPG average was 16.5. At 184,619 miles, MPG average was 17.0. At 184,938 miles, MPG average was 22.2. Quite a difference, impressive. The ...

Michael H. 2008 Cadillac Escalade Sunday, December 13, 2015

I have gone through 1000 miles of engine treatment+Transmission fluid change followed by 4000 miles of Cerma oil ->Filter change -> then another 1000 miles. So I have posted on Veloster forum that I used to get 26.8 MPG at my best on 100% highway trips (cruising at 75~80mph). Here ...

Sungyoung Kim 1998 Ford Mustang V6 168,000 Miles Thursday, June 12, 2014
Dodge Ram 250

Dear Cerma, I started using your products in the summer of 2013. I travel all over the country in my 1991 Dodge D250 two wheel drive with a 5.9 L Cummins turbo diesel. I have a topper on it and drive between 57 and 60 mph when on the highway. I always fuel up the same way and ...

Tom C. Dodge Ram 250 Monday, October 26, 2015
Bagger Motorcycle

December 2007 - I treated my 2002 Harley Davidson Custom Bagger motorcycle on the trip to Arkansas. The main thing that I noticed is the fuel mileage increase of at least 6 mpg. I was very happy as I was driving hard at speeds of at least 75-80 mph all day long on a 1700 mile round ...

Bob M. 2002 Harley Davidson Custom Bagger Motorcycle Tuesday, December 11, 2007

My fiat now runs like a 6cyl. Boy has it got power. It now beats lots of 6cyl. I did my engine using EVO oil and fuel treatment. -- Bill D.

Bill Diel Fiat 500 Sport Monday, January 11, 2016
BMW 318i

Hi everyone!

This post is a "give back" I hope to help a few with this one, as so many helped me with replies on my first post. I learned much. At that time I was asking about re-powering or rebuilding the b43 Onan in my well maintained '83 BMW 318i. The reason was that it smoked ...

Mike Wentz '83 BMW 318i Friday, August 7, 2009
2004 silverado 5.3 v8

O ahhhhhhh mazing :) At first glance, i thought the price was a little crazy.but some in-the-know car guys that i know convinced me to give it a try, and i probably shouldn't have tried it on my only vehicle, but what the hell :D. my vehicle wasn't in bad shape (2004 silverado 5.3 ...

Stephen 2004 silverado 5.3 v8 Thursday, May 23, 2013
2006 Mercedes E350 4Matic

6/5/15: I wanted to let you know my 1997 Toyota is running like a top since I started using your products. I am ready to change to Cerma Oil and am looking forward to ongoing improvement. The transmission shifts like a dream and the power steering no longer "groans" at low speeds. ...

Raul Y. 2006 Mercedes E350 4Matic Friday, June 5, 2015
1996 Toyota Camry

TRY THIS IN YOUR ENGINE.........I was amazed, within 15 mins how better my engine sounded and now my car rides as good as ever........Cerma is awesome. (Facebook Post 2)

Gave the Cerma Motor treatment a try and the oil, and I must say that my car has never run better. I went from ...

Eric Dobbie '96 Toyota Camry Tuesday, July 22, 2014
Pontiac Formula

I bought a bottle of Cerma on the recommendation of a friend at work. My 2001 Pontiac Formula had a lifter tick that I was hoping to get rid of. After putting in the Cermax and letting the engine run for 5 minutes, the tick was GONE! He later asked me if my car had more power, but ...

Richie 2001 Pontiac Formula Thursday, August 12, 2010
Mack 350

This stuff is crazy good although I need to replace injection pump on my Mack 350. This product made the truck run the best it has done for a year. Almost made me forget the pump. Suggestions for a new pump? -- Peter P. via Amazon (Verified Purchase)

Peter P. Mack 350 Sunday, July 24, 2016

Re-post from:http://www.velosterturbo.org/forum/veloster-maintenance/5282-cerma-treatments-oil-lubricants-good-order-222.html#post353642
02-23-2016, 10:09 AM

I will say I'm only 2 days into the treatment with 22k miles on the odo only 100 miles driven since treated and already ...

Sly4c Thursday, March 10, 2016
Bike

Thanks for the emails, i am getting better gas millage in my bike, was at 39 MPG. I am now getting 43 MPG after 300 miles of riding on Cerma! --Greg J. – Wolcott, CT

Greg J. Saturday, June 25, 2016
Diesel Semi-Truck

Just a quick note to tell you what Cerma has done for my trucks.

We put Cerma in the whole system of one truck with 798,000 miles, (engine {470 Detroit}, transmission, and both rear axles). Within 50 miles 95% vibrations were gone, stack smoke was all but gone, and pulling first ...

Everett Schaffer Co Owner E & C Transport, Inc / Terminal 74 for Ace Transportation Houma, Louisiana Sunday, January 28, 2007

Purchased a 1990 Buick Reatta with 143,000 miles on it. It runs great and can only run better with the Cerma products I just purchased (Cerma Engine Value Package) and based on the success of your products in my other vehicles! 1997 Toyota Avalon, 1991 Mercedes 420SEL, 1988 Cadillac ...

Raul Y. 1990 Buick Reatta Friday, June 10, 2016
2002 Ford F-150

Products Used Cerma Engine Treatment, Cerma Motor Oil:
I purchased the Diesel Engine treatment after reading about it and its possible benefits. I am so happy I did. It literally did reduce vibration within seconds of pouring it in my engine. It also slightly reduced the normal ...

Vance W. 2002 Ford F-150 Thursday, August 27, 2015
2015 Denali 2500

Amazing!! This stuff really works as described and then some. I used it three 2015 GMCs (Denali 1500, Denali 2500, and Yukon XL). Smoothed out the idles , don't even know they were running, More responsive, and most importantly no lifter noise when you start them up first thing ...

Amazon Customer 2015 Denali 2500 Wednesday, December 23, 2015
Ford F-150

The amazing Cerma technology! The reason I say amazing is because I worked at Douglas Aircraft in the engineering changes on the DC-9 program way back in the early 1960’s and we had a Cerma type product that did two things, stopped friction and heat, the difference was that technology ...

Capt. Gary Pylant Ford F-150 Thursday, September 3, 2015
Nedal

Would recommend this to anybody who is looking to keep their engine long lasting no matter how many miles is on it. Already used on three of the four cars in our household and have noticed a smoother sound to the engine as well as increased gas mileage on each tank at least getting ...

Nedal Excellent Product Wednesday, March 6, 2013

YOUR ENGINE TREATMENT IS THE BEST VALUE FOR THE MONEY AVAILABLE IN THIS OR ANY OTHER WORLD. IT WORKED SO WELL ON MY INCURABLE INTEGRA ENGINE, I ALMOST CONSIDER IT PROOF THAT WE HAVE ALIEN TECHNOLOGY. --Peter V. (Post 1 via order notes - 04/02/2011)

THIS IS ONE OF THE GREATEST ...

PETER V. 89 ACURA WITH A HONDA B-16 ENGINE Friday, February 21, 2014
1991 Ford Tempo

I am a journeyman machinist/machinery mechanic automotive enthusiasts with 40 years of formal and trade experience.presently I am rebuilding/upgrading a 1991 ford tempo and writing a book.during upgrade research i found about Cerma.as it is a coating, i was EXTREMELY concerned about ...

Bill 1991 Ford Tempo Thursday, September 15, 2011

Bought it used in February, added the motor treatment as I left the dealer. Have averaged 41mpg since I bought it, 18% improvement over the highway rating of 35. (I commute with a total of 3 stop signs or stop lights on the way to work) Here is a copy of each fill-up since new ...

Mitch Jewett 2016 Toyota Camry LE 4 cylinder Thursday, August 9, 2018
Ruger .204 Rifle

I have been using Cerma products for close to two years now in my all my vehicles, tractors, excavator and dump truck. I am totally impressed with all of the products! As a result of my confidence in these products, I thought I would try the firearm foam and grease in my rifles that ...

Paul M. Ruger .204 Rifle Tuesday, February 21, 2017

Update: 4/23/15: Rocket fuel. Just wanted to say that I have now treated all three of our autos with the Engine, trans, and power steering treatments and they are running like new, if not better than new. Keep up the good work. Now I'm going to get the air cond. treatments for ...

Brad T. Chevy Colorado Thursday, April 23, 2015

Dear Great Cerma Product, I have just used the transmission and engine treatment. So Far So Good. I notice an improvement with the transmission, and the engine seems to be idling smother and faster. I expect to be most pleased with my investment on a 191K mile CHEVY Venture 3.4 van. ...

Robert F. Chevy 1998 Venture LS Monday, December 21, 2015
1988 Dodge Box Van

I have used Cerma for about 4 months on different cars and one small truck.

Our 1991 Subaru was getting 19 to 20 miles per gallon when I treated the engine only and saw no increase in mileage but my wife complained about the increase in power because the car had a slow shift ...

Wayne Blakeley 1991 Subaru, 2002 Chrysler AWD Mini Van, 1988 Dodge Box Van Saturday, May 12, 2012
AUD$ 130.00
CERMA ENGINE TREATMENT FOR GASOLINE OR DIESEL...
  • Save 5%
AUD$ 375.00 AUD$ 357.50
CERMA ENGINE TREATMENT DIESEL TRUCKS / SEMIS /...
AUD$ 87.00
CERMA FOR AUTOMATIC TRANSMISSIONS Cerma...
AUD$ 90.00
CERMA MOTORCYCLE TREATMENT Cerma STM-3®...
AUD$ 71.50
Cerma Blue Ice works in all A/C and Regirgeration...