• Cerma STM-3
    Technology and
    Information

    Learn More
  • Cerma Motor Oil
    Technology and
    Information

    Learn More
  • Cerma Blue Ice
    Technology and
    Information

    Learn More
ar15

Cerma Gun Lube. I followed the instructions as directed. I shot a 30 round magazine as fast as I could pull the trigger out of my AR-15. After shooting the rounds I accidentally brushed the barrel of my gun with my forearm and instinctively pulled it away so not to get burned. ...

Dan P. Colt AR-15 Tuesday, May 5, 2015
2003 Honda Odyssey

Doing its magic with my '03 odyssey ! I really did not want to have the AC overhauled very pricey money I don't have so why not try this and see what happens well its only been two days and all ready there's a improvement. -- Tomster via Amazon

Tomster 2003 Honda Odyssey Wednesday, October 29, 2014
1990 560 SEC Benz

I never bother writing reviews, however, this product is FANTASTIC!! 560 SEC Benz with 113k miles, about 30k since valves...UNBELIEVABLE!! Cold start on 1st turn of starter EVERY time, not the 4-6 turns... After the results with oil treatment, did tranny, power steering and fuel ...

Pdidheon 1990 560 SEC Benz Monday, March 23, 2015
2004 silverado 5.3 v8

O ahhhhhhh mazing :) At first glance, i thought the price was a little crazy.but some in-the-know car guys that i know convinced me to give it a try, and i probably shouldn't have tried it on my only vehicle, but what the hell :D. my vehicle wasn't in bad shape (2004 silverado 5.3 ...

Stephen 2004 silverado 5.3 v8 Thursday, May 23, 2013

Before using Cerma, this car, a work car with 160K miles, would jerk every time it changed gears when you drive and the water temperature would be pointed a little over half way up the temperature gauge. I was a little skeptical before but kept reading the testimonials and watching ...

Tuan H. 2002 Honda Accord EX V6 Tuesday, July 19, 2016
Honda 1300 Shadow

I am the guy who spoke with you at length and purchased some fuel treatment, oil additive and gun lube. I put the fuel and oil additives in immediately. I have also run 2 more tanks of fuel with treatment, reducing additive each time and the last tank had none applied. The bike is ...

Kurt P. Honda 1300 Shadow Friday, June 24, 2016

I put Cerma Trans in and have noticed the trans shifts better and the temp gauge is reading cooler.

– Drew (10/25/2012, 09:35 PM)

Drew Challenger RT Thursday, October 25, 2012

Hi John. I decided to try Cerma and my first use was in my daughter's 2002 Mazda Tribute with about 100,000 kms on it. It was running a bit rough and mileage was low 20's per gallon. I treated it and then we went on a family trip, loaded with 4 adults and full of golf clubs and ...

Tom D. 2002 Mazda Tribute Tuesday, February 18, 2014
2010 BMW 550i

Hi, After 2000 miles my 2010 BMW 550i it runs better, no engine noise and 2-3 more MPG. Thanks ! -- Stephen K.

Steven K. 2010 BMW 550i Tuesday, March 8, 2016
Mitsubishi Challenger

Hullo John,
I bought 1 bottle of Cerma STM-3 Engine Treatment and 1 bottle of Cerma STM-3 Automatic Transmission Treatment from you in May 2008. I treated my Mitsubishi Challenger(see attachment) 4x4 engine which is a 3Ltr V6 in the engine and the transmission. I followed your ...

J Wulf Mitsubishi Challenger Sunday, February 8, 2009
Fedex

FedEx driver reports truck running smoother with increased power, as prior the truck was having problems getting up to freeway speeds. Driver was very happy to have treated this truck with Cerma Engine Treatment, and is looking forward to changing out to Cerma Motor Oil so he can ...

Master Admin Fedex Ground Delivery Truck Monday, August 17, 2015

Re-post from:http://www.velosterturbo.org/forum/veloster-maintenance/5282-cerma-treatments-oil-lubricants-good-order-222.html#post353642
02-23-2016, 10:09 AM

I will say I'm only 2 days into the treatment with 22k miles on the odo only 100 miles driven since treated and already ...

Sly4c Thursday, March 10, 2016
Acura RL Automatic Transmission

Fuel Treatment from April 14th, 2015: Great stuff. My gas mileage definitely goes up steadily, as per my digital gauge, when I use this stuff. I absolutely love this product. My engine runs very smooth with this product. Highly recommended. -- MichiganSooner via Amazon

Transmission ...

MichiganSooner Acura RL Automatic Transmission Monday, April 13, 2015
Bike

Thanks for the emails, i am getting better gas millage in my bike, was at 39 MPG. I am now getting 43 MPG after 300 miles of riding on Cerma! --Greg J. – Wolcott, CT

Greg J. Saturday, June 25, 2016

In my application, 1991 BMW 750i 5.0L 12 cylinder, I was mainly trying to correct annoying hydraulic lifter noise without having to replace any lifters. The Cerma product worked almost immediately to quiet all noisy lifters and they have remained quiet for the last 30K miles on an ...

Mark C. McCafferty, P.E. 1991 BMW 750i 5.0L 12 cylinder Tuesday, February 18, 2014
Honda Pilot 2004 3.5L

Several tens of thousands of miles ago, I found out about Cerma Engine Treatment -- yep, I was skeptical. But talking with these wonderful folks convinced me to try it. After adding to the oil, I noticed a problem of concern: at the stop light, my car was so quiet i couldn't hear ...

John T. Honda Pilot 2004 3.5L Tuesday, February 6, 2018

This product saved me from loosing the use of my furnace for a week in December, I was leaving my home in north IA. I heard a strange noise from the basement and went to investigate, it sounded like a bad bearing, I opened the case of the furnace and it got louder, shut furnace off ...

James, VAS-PRO 11 year old furnace Thursday, July 26, 2018
Dodge Ram 250

Dear Cerma, I started using your products in the summer of 2013. I travel all over the country in my 1991 Dodge D250 two wheel drive with a 5.9 L Cummins turbo diesel. I have a topper on it and drive between 57 and 60 mph when on the highway. I always fuel up the same way and ...

Tom C. Dodge Ram 250 Monday, October 26, 2015
40 FT Meridian Yacht

The boat is going over 28 MPH. Granted clean bottom and props but I don’t believe it ever went over 26ish on this boat. It is a 40 FT Meridian Yacht weighing 17 tons. Top end speed was increased about 10% and that is before we start with the CERMAX Motor Oil.

Leigh Overland 40 FT Meridian Yacht Wednesday, June 4, 2014

So...I just got the oil changed to Cerma 5W30 and could feel a huge difference just starting the car up. Engine vibration in the pedal has gone almost to zero and the acceleration feels smoother. The best way to describe how it feels is by watching the test video that john put up ...

CH3mist - Veloster Forum Member Hyundai Veloster Saturday, February 1, 2014
Carbide Chain Saw

I think we performed a pretty significant experiment with your product today. My training officer did not return to the office but I will get more information tomorrow. We took 2 identical roof cutting carbide chain saws and had the same operator on the same roof make cuts one after ...

Chief Doug Carbide Chain Saws Wednesday, April 1, 2015
2001 Honda Accord V6

1st attempt to test this Cerma engine treatment on my 01 Accord V6 - org 68,000mi on SEP-02 2015. Brand new Mobile 1 full synthetic oil w/ Honda genuine filter before engine treatment applied, this accord runs avg mpg 18 / 24. Engine seems quieter after 80+ miles on the road. -- ...

Spectacular Motoring 2001 Honda Accord V6 Thursday, September 3, 2015
Kia Optima

Good afternoon,
I wanted to report your product results for my 2009 Kia Optima with 35k miles. I added a bottle to the automatic transmission and have experienced a much smoother shifting pattern. Otherwise not much to report.

I added one bottle to the engine oil and have noticed ...

Kevin Udell 2009 Kia Optima with 35k miles Thursday, August 5, 2010
Ruger .204 Rifle

I have been using Cerma products for close to two years now in my all my vehicles, tractors, excavator and dump truck. I am totally impressed with all of the products! As a result of my confidence in these products, I thought I would try the firearm foam and grease in my rifles that ...

Paul M. Ruger .204 Rifle Tuesday, February 21, 2017
Ford F-150

The amazing Cerma technology! The reason I say amazing is because I worked at Douglas Aircraft in the engineering changes on the DC-9 program way back in the early 1960’s and we had a Cerma type product that did two things, stopped friction and heat, the difference was that technology ...

Capt. Gary Pylant Ford F-150 Thursday, September 3, 2015
Intake

So here we are at 50,000 miles. Picture here is the cleanest intake valves ever seen on a GDI motor, by two EQUUS techs with 35 years experience between them. CERMA works. Way beyond anything.... Those of you contemplating its use, what are you waiting for. The SS turbo is going ...

Peter K. (aka Gaijii) From Veloster Forum -- CERMA Treatments/Oil/Lubricants: For the good of the order Sunday, November 1, 2015
2014 Jeep Grand Cherokee

Cerma Engine Treatment. My wife bought a brand new 2014 Jeep Grand Cherokee last September. She had approximately 15,000 miles on the engine when I added the Cerma Engine Treatment. After the suggested 3,000 miles I changed the oil and used CERMAX 5-20W oil. She drove an additional ...

Dan P. 2014 Jeep Grand Cherokee Tuesday, May 5, 2015
AUD$ 130.00
CERMA ENGINE TREATMENT FOR GASOLINE OR DIESEL...
  • Save 5%
AUD$ 375.00 AUD$ 357.50
CERMA ENGINE TREATMENT DIESEL TRUCKS / SEMIS /...
AUD$ 87.00
CERMA FOR AUTOMATIC TRANSMISSIONS Cerma...
AUD$ 90.00
CERMA MOTORCYCLE TREATMENT Cerma STM-3®...
AUD$ 71.50
Cerma Blue Ice works in all A/C and Regirgeration...