• Cerma STM-3
    Technology and

    Learn More
  • Cerma Motor Oil
    Technology and

    Learn More
  • Cerma Blue Ice
    Technology and

    Learn More

Hi, Just wanted let you know about the incredible results experienced with your Auto Transmission Treatment. I had already used the Engine Treatment around 1 ½ years ago and then added the Transmission Treatment in March 2014. When I first bought the car around 6 years ...

Robin V. 1996 Mitsubishi Magna V6 Sedan Thursday, September 10, 2015

Purchased a 1990 Buick Reatta with 143,000 miles on it. It runs great and can only run better with the Cerma products I just purchased (Cerma Engine Value Package) and based on the success of your products in my other vehicles! 1997 Toyota Avalon, 1991 Mercedes 420SEL, 1988 Cadillac ...

Raul Y. 1990 Buick Reatta Friday, June 10, 2016
Chevy Camarom RS

I put it in the engine oil and transmission. Transmission stopped slipping on very first drive home from work. I could not believe it!

Anonymous 1991 Chevy Camarom RS with 213,000 miles on it Saturday, July 31, 2010
2014 Jeep Grand Cherokee

Cerma Engine Treatment. My wife bought a brand new 2014 Jeep Grand Cherokee last September. She had approximately 15,000 miles on the engine when I added the Cerma Engine Treatment. After the suggested 3,000 miles I changed the oil and used CERMAX 5-20W oil. She drove an additional ...

Dan P. 2014 Jeep Grand Cherokee Tuesday, May 5, 2015
40 FT Meridian Yacht

The boat is going over 28 MPH. Granted clean bottom and props but I don’t believe it ever went over 26ish on this boat. It is a 40 FT Meridian Yacht weighing 17 tons. Top end speed was increased about 10% and that is before we start with the CERMAX Motor Oil.

Leigh Overland 40 FT Meridian Yacht Wednesday, June 4, 2014
Diesel Semi-Truck

Just a quick note to tell you what Cerma has done for my trucks.

We put Cerma in the whole system of one truck with 798,000 miles, (engine {470 Detroit}, transmission, and both rear axles). Within 50 miles 95% vibrations were gone, stack smoke was all but gone, and pulling first ...

Everett Schaffer Co Owner E & C Transport, Inc / Terminal 74 for Ace Transportation Houma, Louisiana Sunday, January 28, 2007

Dear Great Cerma Product, I have just used the transmission and engine treatment. So Far So Good. I notice an improvement with the transmission, and the engine seems to be idling smother and faster. I expect to be most pleased with my investment on a 191K mile CHEVY Venture 3.4 van. ...

Robert F. Chevy 1998 Venture LS Monday, December 21, 2015
Pontiac Formula

I bought a bottle of Cerma on the recommendation of a friend at work. My 2001 Pontiac Formula had a lifter tick that I was hoping to get rid of. After putting in the Cermax and letting the engine run for 5 minutes, the tick was GONE! He later asked me if my car had more power, but ...

Richie 2001 Pontiac Formula Thursday, August 12, 2010
Series 60 Detroit

I own a trucking company and have been amazed at the results of the Cerma Engine Treatment and Cerma Motor Oils. I purchased Cerma because my older Series 60 Detroit was smoking badly, particularly when off the throttle. Even though overhauled only about a year and a half ago, the ...

Tom Hoover Series 60 Detroit Sunday, April 15, 2012
Mercedes Benz '91 560 SEC


I heard about Cerma oil treatment from a friend who had amazing results with a sluggish high-mile Acura minivan. I treated my Mercedes Benz '91 560 SEC (113k miles) 4 weeks ago with Cerma engine, transmission, power steering and fuel treatment and can report ...

Patrick M. Mercedes Benz '91 560 SEC Monday, April 6, 2015

6/3/2015: John, I have been using the Cerma Evo grade oil in my 2012 Prius for over a year now an was thrilled to get 53-54 miles to the gallon. Recently, I just got lazy one day and took my Prius in to the Valvaline oil change and had them put in their top of the line fully synthetic ...

Steve A. (Cincinnati) 2012 Prius (58 MPG) Wednesday, June 3, 2015
Yanmar Tractor

I was a skeptic, but when I added the Cerma Engine Oil Treatment to my Yanmar, the change was amazing! Within 20 minutes the engine smoothed out, became much quieter, and is clearly running much better. I can pull an extra 300-400 rpm – that means more horsepower out the shaft – without ...

Chuck W. Yanmar Tractor Thursday, September 3, 2015
Alliant Energy

We have used Cerma in a gear box which is 1 of 2 identical units. The one
we treated was initially running 60 decrees hotter than the other one. We want them to
run at no more than 180 degrees. The manufacturing company tried changing out the
gears and in essence did everything ...

Eric Krahenbuhl Alliant Energy, Emery Generating Station Monday, July 16, 2012
1987 BMW M6

Hi John, I want you to know that the Cerma Transmission Treatment fixed my 25 year old BMW M6 manual tranny, which did not want to go into first gear much before. This appears to be a known issue with those Getrag gearboxes. The Cerma STM-3 Engine Treatment made this same vehicle ...

Glenn 1987 BMW M6 and 1989 Chrysler Dynasty Wednesday, February 29, 2012
WV Passat 2001

Great product, Works as advertised! Used on 4 cylinder WV Passat 2001 (Diesel) and 2011 Kia Forte (Gasoline). After treating the engines with this product and driving 30 miles the cars became quieter. In addition, the engine's operating temperature decreased and after couple of months ...

Gi R. WV Passat 2001 Saturday, November 30, 2013
2006 Jeep Grand Cherokee

I tried Cerma in my truck first and after 1 1/2 months my gas mileage went up by 3 mpg . My 2006 Jeep Grand Cherokee 3.7 L went from 14 mpg to 17 mpg local and hyw from 22 mpg to 25 mpg. Then I put it in my lawn mower. Before it was smoking and after 3 times mowing the lawn it ...

Seth W. 2006 Jeep Grand Cherokee 3.7 L Tuesday, May 5, 2015
1991 Ford Tempo

I am a journeyman machinist/machinery mechanic automotive enthusiasts with 40 years of formal and trade experience.presently I am rebuilding/upgrading a 1991 ford tempo and writing a book.during upgrade research i found about Cerma.as it is a coating, i was EXTREMELY concerned about ...

Bill 1991 Ford Tempo Thursday, September 15, 2011
2011 Ford Fusion SE

8/27/14 - FYI! I had my car at the dealer this morning for a recall service appt. My 2011 Fusion with 81k miles on the 2.5L 4 cyl duratec engine was "quieter then a brand new engine in any car found on the lot..." according to the service technician who worked on the car.

8/14/14 ...

Douglas E. Immediate improvement! - 2011 Ford Fusion SE Sunday, October 11, 2015
2002 Mack Semi

I own a 2002 Mack semi. My truck started using 2 to 3 gallons of oil per week. I was told I needed to rebuild the motor, rings, sleeves, rod, and main bearings. The motor had an excessive amount of blow by. I added Cerma and followed the instructions carefully. Over the next three ...

deliveredtrucking@ 2002 Mack Semi Thursday, April 23, 2015
2004 Ford F350 6.0

Works. 'Lil spendy but damn worked. Bought In april 2014 used in my '04 6.0 F350 4x4 an put some in my dad's dodge '05 3500 5.9 he even commented + on this, wish could afford more often tried others this works the best for me an my 6.0. Great product the Diesel fuel treatment better ...

D. Watson 2004 Ford F350 6.0 Tuesday, March 8, 2016

Wanted to update on the Lancer. We are 2k miles into the cerma max 5w40 oil and I pulled the dipstick... No joke it looks like I just did the oil change. I'll post up pics when I get a chance. As a reminder the Lancer has 111k so I expected to see some dark oil. But it was completely ...

Turbomatte Mitsubishi Lancer Thursday, June 12, 2014
2001 Peterbilt

Heard of this product from a friend put it in my dads 2001 Peterbilt Generator after about 2 min of running it quieted down and I couldn't even tell it was running.. Can't wait to put it in the engine and see what kind of fuel mileage he gets. Great product very satisfied. – John ...

John Leckington 2001 Peterbilt Generator Wednesday, March 7, 2012
2003 Honda Odyssey

Doing its magic with my '03 odyssey ! I really did not want to have the AC overhauled very pricey money I don't have so why not try this and see what happens well its only been two days and all ready there's a improvement. -- Tomster via Amazon

Tomster 2003 Honda Odyssey Wednesday, October 29, 2014

I've tried them all and Cerma is by far the best product on the market! Better fuel economy, my engine runs smother and quieter than when I had it rebuilt, you can feel the increased power through out the power curve and I fill up less than I deed prior to treating my engine and am ...

David T 2002 Lexus RX 300 Sunday, September 7, 2014
2001 Honda Accord V6

1st attempt to test this Cerma engine treatment on my 01 Accord V6 - org 68,000mi on SEP-02 2015. Brand new Mobile 1 full synthetic oil w/ Honda genuine filter before engine treatment applied, this accord runs avg mpg 18 / 24. Engine seems quieter after 80+ miles on the road. -- ...

Spectacular Motoring 2001 Honda Accord V6 Thursday, September 3, 2015

So here we are at 50,000 miles. Picture here is the cleanest intake valves ever seen on a GDI motor, by two EQUUS techs with 35 years experience between them. CERMA works. Way beyond anything.... Those of you contemplating its use, what are you waiting for. The SS turbo is going ...

Peter K. (aka Gaijii) From Veloster Forum -- CERMA Treatments/Oil/Lubricants: For the good of the order Sunday, November 1, 2015

I recently SiC treated a 1100cc motor on a 1984 Honda v65 Sabre VF100S and began with these compression numbers:

Cylinder #1: 120/170 Cylinder #2 : 142/170 Cylinder #3 : 138/170 Cylinder #4 : 140/170

After treatment, compression improved significantly. My post-treatment ...

Robert Kientop 1984 Honda v65 Sabre VF100S Wednesday, October 14, 2015
AUD$ 130.00
  • Save 5%
AUD$ 375.00 AUD$ 357.50
AUD$ 87.00
AUD$ 90.00
AUD$ 71.50
Cerma Blue Ice works in all A/C and Regirgeration...